Strut Brace Install PDF Print E-mail
Written by Administrator   
Thursday, 10 June 2010 15:07

I purchased a Petty's Garage tower strut brace. I got the red one to match some of the other trim items on the car. This installed quite easily, the only tricky part is drilling a hole in the cowl cross member. There is not much room above the intake manifold so drilling this hole square to the surface of the square cross member is difficult. Here is a picture of it installed.

I also added some new braided hoses. In the above picture you can see the coolant overflow line and the intake breather line. I also changed the lines on the catch can so the fittings and hoses match.

Last Updated on Thursday, 28 April 2011 12:54